Laadpalen
Assortiment laadpalen
Eigen branding
Accessoires
Standalone Payment Solution
Duo Wide Payment Panel
Sectoren
Particulier
Publiek
Semi-publiek
Fleet (Wagenpark)
Kennisbank
Downloads
Installatie video’s
Dynamic Load Management
Master – Slave installatie
ECClite
Over ons
Over ons
Actueel
Vacatures
Compliance & Ethiek
Pers & Media
Mijn Ecotap
Contact
Zoek naar:
Zoekknop
Menu
Laadpalen
Assortiment laadpalen
Eigen branding
Accessoires
Standalone Payment Solution
Duo Wide Payment Panel
Sectoren
Particulier
Publiek
Semi-publiek
Fleet (Wagenpark)
Kennisbank
Downloads
Installatie video’s
Dynamic Load Management
Master – Slave installatie
ECClite
Over ons
Over ons
Actueel
Vacatures
Compliance & Ethiek
Pers & Media
Mijn Ecotap
Contact
Zoek naar:
Zoekknop
At any point between the white and orange wires, a multimeter reads 60 Ohms.
( please measure with power removed )
The brown wire is not connected to the module; instead, it runs to the PV (-12V) terminal.
When connecting new wiring to existing wiring, it is easiest to do this with one of the kWh meters where no double wiring is used.
If a resistor (120 Ohms) is used on the kWh meters, it must be removed, leaving two resistors in the circuit (load balancer and controller module).
The utility-meter (with coils) is connected according to the above table, see column: Kilowatt hour meters.
This utility-meter always has address 3 on the modus circuit.